1997 CLK-GTR (TC-01)

1/10 RC 1997 Mercedes-Benz CLK-GTR (TC-01) byggesett.

Har tidligere blitt levert på TA-03R og TT-01E chassis, men kommer nå på TC-01 chassis som er et høyytelse chassis med lavt tyngdepunkt.

Mercedes-Benz CLK-GTR tok seks seire i FIA GT-mesterskapet i 1997. Den hadde 6-liters V12 motor og over 600 hestekrefter.

Må kompletteres med:

• Radio og mottaker
• 540 type motor
• Lavprofil servo
• ESC (fartskontroller) med liten formfaktor
• NiMH eller LiPO batteri
• Batterilader
• PS Lakk

Anbefales:

• Kulelagre

Tamiya har et bredt sortiment med maling. Du kan se hele sortimentet her.

Anbefalte farger:

PS-5 Black
PS-12 Silver
PS-31 Smoke
TS-17 Gloss Aluminum
TS-29 Semi Gloss Black (alternativ X-18 Semi Gloss Black)
X-8 Lemon Yellow
X-11 Chrome Silver

Fra produsenten:

This R/C model assembly kit recreates the Mercedes-Benz CLK-GTR car which took six wins in dominating the 1997 FIA GT Championship. Although inheriting the 2-door coupe form and front section of its base road car, the racecar looked rather different and that aerodynamically honed form is recreated by a polycarbonate body, while separately molded components are used for the nose emblem, A pillar-mounted side mirrors, rear spoiler and rear wing. A full sticker sheet recreates this successful car’s livery to round off the model.

TC-01: Seriously Low-Profile
This durable composite monocoque-frame chassis provides shaft driven 4WD from a central motor via front and rear propeller shafts, with oil filled gear differentials. 4-wheel independent double wishbone suspension employs long arms, plus inboard setups front and rear with oil dampers actuated by push rods and rocker arms to allow the use of low-profile bodies. Adjust spacer width to easily alter camber, skid and toe angle settings. Both suspension arms and uprights are identical left, right, front and rear, for more efficient pit work.

Specifications
★Length: 470mm, width: 194mm, height: 115mm ♦Wheelbase: 257mm ♦Tread: 159mm (front), 163mm (rear) ♦Tire width/diameter: 26/67mm (front & rear) ♦Composite monocoque-frame chassis ♦Midship motor, shaft-driven 4WD ♦Front & rear oil-filled gear differentials ♦3-piece steering tie-rod ♦Front & rear inboard 4-wheel independent double wishbone suspension ♦CVA oil dampers (front & rear) ♦Gear ratio = 7:50:1~5.25:1 (6.56:1 with kit 24T pinion) ♦Type 540 motor and electronic speed controller (ESC) are sold separately.

Separately Required Items
♦Type 540 motor ♦2-channel R/C system w/ESC ♦R6/AA/UM3 batteries for transmitter ♦Battery pack & charger